286afad919
* Mock S60 * cleanup * Start refactor of OLED init * Setup timers roughly * Set Vector table offset correctly Update system_stm32f1xx.c * Update OLED.cpp * Update stm32f1xx_hal_msp.c * Update configuration.h * I2C init before GPIO From Errata Update stm32f1xx_hal_msp.c Update Software_I2C.h Allow no hardware I2C * I2C BB run bus unlock at init * cleanups * Software I2C for now * Mildly more graceful Interpolate * Handle is powered by DC Update Power.cpp Update drawPowerSourceIcon.cpp Update configuration.h Update Setup.cpp * Cleanup HomeScreen * Segment remap oled at init * Cleanup * Update MOVThread.cpp * Fix PWM Init * Fix adc2 trigger * Update configs * Fixup warning * Saner default config * Update ThermoModel.cpp * Util for current@voltage * Hub238 warning * Add hub238 handling in power mode * Update USBPDDebug_FUSB.cpp * HUSB238 debug * Hook PSU Limit * Use wrapping section of GRAM for scroll Update OLED.hpp * Update NTC table * Fix HUB voltage picker * Cleanup * Larger tip filter * Calibrate in a bunch closer Update ThermoModel.cpp * Update configuration.h * Update HUB238.cpp * Update configuration.h * Movement Pin * Update BSP.cpp * tim2 irq * Rough timer conversion (adc broken) but movement working * Fix tim2 start * Faster base PWM * Ensure utils grabs config * Add wattage limiter tolerance for device * Speed up PWM and enable PWM current limiting * tune for 12v * Prevent start until PD done * Update configuration.h * Add HUB238 check for have re-negotiated * Adjust timer to avoid noise when its possible
26 lines
476 B
C++
26 lines
476 B
C++
/*
|
|
* preRTOS.c
|
|
*
|
|
* Created on: 29 May 2020
|
|
* Author: Ralim
|
|
*/
|
|
|
|
#include "BSP.h"
|
|
#include "I2CBB.hpp"
|
|
#include "Pins.h"
|
|
#include "Setup.h"
|
|
#include <I2C_Wrapper.hpp>
|
|
|
|
void preRToSInit() {
|
|
/* Reset of all peripherals, Initializes the Flash interface and the Systick.
|
|
*/
|
|
HAL_Init();
|
|
Setup_HAL(); // Setup all the HAL objects
|
|
BSPInit();
|
|
#ifdef I2C_SOFT
|
|
I2CBB::init();
|
|
#endif
|
|
/* Init the IPC objects */
|
|
FRToSI2C::FRToSInit();
|
|
}
|