347968e4ef
Settings menu works Movement working & TMP calibrated Tip reading sensibily Accuracy seems ok Trimmed down overshoot by biasing integral Saving to flash working, detailed idle Sleep mode Description scrolls Building for DFU working Motion detection update Use manual alg instead, using highpass filter, then sum current change vs rolling average Re-shuffle the pwm code organisation
1.8 KiB
1.8 KiB
Version Changes
V2.00
- Complete re-write of the low layer system to use the STM32 HAL for easier development
- This allowed easier setup for the new ADC auto measuring system
- Better tip PWM control
- Moved to FreeRTOS for scheduling
- Complete re-write from blank
- Added detailed screen views
- Added smaller font for said screen views
V1.17
- Added blinking cooldown display
- Allowed smaller sleep timeout values
- New font!
- Automatic startup option
V1.16
- Added automatic rotation support
- Added power display graph
V1.15
- Added support for a custom bootup logo to be programmed via the DFU bootloader.
V1.14
- Changed input voltage cutoff to be based on cell count rather than voltage.
V1.13
- Swapped buttons for menu to prevent accidentally changing first menu item
- Added auto key repeat.
V1.12
- Increases sensitivity options to be 1*9 with 0 off state
- Fixes issue where going from COOL *> soldering can leave screen off.
V1.11
- Boost mode
- Change sensitivity options to be 1*8
V1.10
- Adds help text to settings
- Improves settings for the display update rate
V1.09
- Adds display modes, for slowing down or simplifying the display
V1.08
- Fix settings menu not showing flip display
V1.07
- Adds shutdown time to automatically shutdown the iron after inactivity
V1.06
- Changes H and C when the iron is heating to the minidso chevron like images
V1.05
- Adds ability to calibrate the input voltage measurement
V1.04
- Increased accuracy of the temperature control
- Improved PID response slightly
- Allows temperature offset calibration
- Nicer idle screen
V1.03
- Improved Button handling
- Ability to set motion sensitivity
- DC voltmeter page shows input voltage
V1.02
- Adds hold both buttons on IDLE to access the therometer mode.
- Changes the exit soldering mode to be holding both buttons (Like original firmware).