347968e4ef
Settings menu works Movement working & TMP calibrated Tip reading sensibily Accuracy seems ok Trimmed down overshoot by biasing integral Saving to flash working, detailed idle Sleep mode Description scrolls Building for DFU working Motion detection update Use manual alg instead, using highpass filter, then sum current change vs rolling average Re-shuffle the pwm code organisation
54 lines
2.2 KiB
C
54 lines
2.2 KiB
C
/*
|
|
* Settings.h
|
|
*
|
|
* Created on: 29 Sep 2016
|
|
* Author: Ralim
|
|
*
|
|
* Houses the system settings and allows saving / restoring from flash
|
|
*/
|
|
|
|
#ifndef SETTINGS_H_
|
|
#define SETTINGS_H_
|
|
#include <stdint.h>
|
|
#include "stm32f1xx_hal.h"
|
|
#define SETTINGSVERSION 2 /*Change this if you change the struct below to prevent people getting out of sync*/
|
|
//Display Speeds
|
|
#define DISPLAYMODE_FAST (0x00)
|
|
#define DISPLAYMODE_MEDIUM (0x01)
|
|
#define DISPLAYMODE_SLOW (0x02)
|
|
//Rounding Modes
|
|
#define ROUNDING_NONE (0x00)
|
|
#define ROUNDING_FIVE (0x01)
|
|
#define ROUNDING_TEN (0x02)
|
|
|
|
/*
|
|
* This struct must be a multiple of 2 bytes as it is saved / restored from flash in uint16_t chunks
|
|
*/
|
|
typedef struct {
|
|
uint16_t SolderingTemp; //current set point for the iron
|
|
uint32_t SleepTemp; //temp to drop to in sleep
|
|
uint8_t version; //Used to track if a reset is needed on firmware upgrade
|
|
uint8_t SleepTime; //minutes timeout to sleep
|
|
uint8_t cutoutSetting :3; //(3 bits) The voltage we cut out at for under voltage
|
|
uint8_t powerDisplay :1; //Toggle to swap the arrows with a power readout instead
|
|
uint8_t OrientationMode :2; //If true we want to invert the display for lefties
|
|
uint8_t sensitivity :5; //Sensitivity of accelerometer (5 bits)
|
|
uint8_t autoStartMode :2; //Should the unit automatically jump straight into soldering mode when power is applied
|
|
uint8_t ShutdownTime :6; //Time until unit shuts down if left alone
|
|
uint8_t boostModeEnabled :1; //Boost mode swaps BUT_A in soldering mode to temporary soldering temp over-ride
|
|
uint8_t coolingTempBlink :1; //Should the temperature blink on the cool down screen until its <50C
|
|
uint8_t advancedScreens :1; //If enabled we draw more detailed screens with smaller fonts
|
|
uint16_t voltageDiv; //Voltage divisor factor
|
|
uint16_t BoostTemp; //Boost mode set point for the iron
|
|
uint32_t padding; //This is here for in case we are not an even divisor so that nothing gets cut off
|
|
} systemSettingsType;
|
|
|
|
extern systemSettingsType systemSettings;
|
|
|
|
void saveSettings();
|
|
void restoreSettings();
|
|
uint8_t lookupVoltageLevel(uint8_t level);
|
|
void resetSettings();
|
|
void showBootLogoIfavailable();
|
|
#endif /* SETTINGS_H_ */
|