Ben V. Brown
|
286afad919
|
S60 Support (#1692)
* Mock S60
* cleanup
* Start refactor of OLED init
* Setup timers roughly
* Set Vector table offset correctly
Update system_stm32f1xx.c
* Update OLED.cpp
* Update stm32f1xx_hal_msp.c
* Update configuration.h
* I2C init before GPIO
From Errata
Update stm32f1xx_hal_msp.c
Update Software_I2C.h
Allow no hardware I2C
* I2C BB run bus unlock at init
* cleanups
* Software I2C for now
* Mildly more graceful Interpolate
* Handle is powered by DC
Update Power.cpp
Update drawPowerSourceIcon.cpp
Update configuration.h
Update Setup.cpp
* Cleanup HomeScreen
* Segment remap oled at init
* Cleanup
* Update MOVThread.cpp
* Fix PWM Init
* Fix adc2 trigger
* Update configs
* Fixup warning
* Saner default config
* Update ThermoModel.cpp
* Util for current@voltage
* Hub238 warning
* Add hub238 handling in power mode
* Update USBPDDebug_FUSB.cpp
* HUSB238 debug
* Hook PSU Limit
* Use wrapping section of GRAM for scroll
Update OLED.hpp
* Update NTC table
* Fix HUB voltage picker
* Cleanup
* Larger tip filter
* Calibrate in a bunch closer
Update ThermoModel.cpp
* Update configuration.h
* Update HUB238.cpp
* Update configuration.h
* Movement Pin
* Update BSP.cpp
* tim2 irq
* Rough timer conversion (adc broken) but movement working
* Fix tim2 start
* Faster base PWM
* Ensure utils grabs config
* Add wattage limiter tolerance for device
* Speed up PWM and enable PWM current limiting
* tune for 12v
* Prevent start until PD done
* Update configuration.h
* Add HUB238 check for have re-negotiated
* Adjust timer to avoid noise when its possible
|
2023-06-03 20:05:31 +10:00 |
|