S60 Support (#1692)

* Mock S60

* cleanup

* Start refactor of OLED init

* Setup timers roughly

* Set Vector table offset correctly

Update system_stm32f1xx.c

* Update OLED.cpp

* Update stm32f1xx_hal_msp.c

* Update configuration.h

* I2C init before GPIO

From Errata

Update stm32f1xx_hal_msp.c

Update Software_I2C.h

Allow no hardware I2C

* I2C BB run bus unlock at init

* cleanups

* Software I2C for now

* Mildly more graceful Interpolate

* Handle is powered by DC

Update Power.cpp

Update drawPowerSourceIcon.cpp

Update configuration.h

Update Setup.cpp

* Cleanup HomeScreen

* Segment remap oled at init

* Cleanup

* Update MOVThread.cpp

* Fix PWM Init

* Fix adc2 trigger

* Update configs

* Fixup warning

* Saner default config

* Update ThermoModel.cpp

* Util for current@voltage

* Hub238 warning

* Add hub238 handling in power mode

* Update USBPDDebug_FUSB.cpp

* HUSB238 debug

* Hook PSU Limit

* Use wrapping section of GRAM for scroll

Update OLED.hpp

* Update NTC table

* Fix HUB voltage picker

* Cleanup

* Larger tip filter

* Calibrate in a bunch closer

Update ThermoModel.cpp

* Update configuration.h

* Update HUB238.cpp

* Update configuration.h

* Movement Pin

* Update BSP.cpp

* tim2 irq

* Rough timer conversion (adc broken) but movement working

* Fix tim2 start

* Faster base PWM

* Ensure utils grabs config

* Add wattage limiter tolerance for device

* Speed up PWM and enable PWM current limiting

* tune for 12v

* Prevent start until PD done

* Update configuration.h

* Add HUB238 check for have re-negotiated

* Adjust timer to avoid noise when its possible

source/Core/BSP/Sequre_S60/preRTOS.cpp

@@ -0,0 +1,25 @@
+/*
+ * preRTOS.c
+ *
+ *  Created on: 29 May 2020
+ *      Author: Ralim
+ */
+
+#include "BSP.h"
+#include "I2CBB.hpp"
+#include "Pins.h"
+#include "Setup.h"
+#include <I2C_Wrapper.hpp>
+
+void preRToSInit() {
+  /* Reset of all peripherals, Initializes the Flash interface and the Systick.
+   */
+  HAL_Init();
+  Setup_HAL(); // Setup all the HAL objects
+  BSPInit();
+#ifdef I2C_SOFT
+  I2CBB::init();
+#endif
+  /* Init the IPC objects */
+  FRToSI2C::FRToSInit();
+}