S60 Support (#1692)

* Mock S60

* cleanup

* Start refactor of OLED init

* Setup timers roughly

* Set Vector table offset correctly

Update system_stm32f1xx.c

* Update OLED.cpp

* Update stm32f1xx_hal_msp.c

* Update configuration.h

* I2C init before GPIO

From Errata

Update stm32f1xx_hal_msp.c

Update Software_I2C.h

Allow no hardware I2C

* I2C BB run bus unlock at init

* cleanups

* Software I2C for now

* Mildly more graceful Interpolate

* Handle is powered by DC

Update Power.cpp

Update drawPowerSourceIcon.cpp

Update configuration.h

Update Setup.cpp

* Cleanup HomeScreen

* Segment remap oled at init

* Cleanup

* Update MOVThread.cpp

* Fix PWM Init

* Fix adc2 trigger

* Update configs

* Fixup warning

* Saner default config

* Update ThermoModel.cpp

* Util for current@voltage

* Hub238 warning

* Add hub238 handling in power mode

* Update USBPDDebug_FUSB.cpp

* HUSB238 debug

* Hook PSU Limit

* Use wrapping section of GRAM for scroll

Update OLED.hpp

* Update NTC table

* Fix HUB voltage picker

* Cleanup

* Larger tip filter

* Calibrate in a bunch closer

Update ThermoModel.cpp

* Update configuration.h

* Update HUB238.cpp

* Update configuration.h

* Movement Pin

* Update BSP.cpp

* tim2 irq

* Rough timer conversion (adc broken) but movement working

* Fix tim2 start

* Faster base PWM

* Ensure utils grabs config

* Add wattage limiter tolerance for device

* Speed up PWM and enable PWM current limiting

* tune for 12v

* Prevent start until PD done

* Update configuration.h

* Add HUB238 check for have re-negotiated

* Adjust timer to avoid noise when its possible

source/Core/BSP/Sequre_S60/Setup.h

@@ -0,0 +1,38 @@
+/*
+ * Setup.h
+ *
+ *  Created on: 29Aug.,2017
+ *      Author: Ben V. Brown
+ */
+
+#ifndef SETUP_H_
+#define SETUP_H_
+
+#ifdef __cplusplus
+extern "C" {
+#endif
+
+#include "stm32f1xx_hal.h"
+
+extern ADC_HandleTypeDef hadc1;
+extern ADC_HandleTypeDef hadc2;
+extern DMA_HandleTypeDef hdma_adc1;
+
+extern DMA_HandleTypeDef hdma_i2c1_rx;
+extern DMA_HandleTypeDef hdma_i2c1_tx;
+extern I2C_HandleTypeDef hi2c1;
+
+extern IWDG_HandleTypeDef hiwdg;
+
+extern TIM_HandleTypeDef htim4;
+extern TIM_HandleTypeDef htim2;
+void                     Setup_HAL();
+uint16_t                 getADCHandleTemp(uint8_t sample);
+uint16_t                 getADCVin(uint8_t sample);
+void                     HAL_TIM_MspPostInit(TIM_HandleTypeDef *htim); // Since the hal header file does not define this one
+
+#ifdef __cplusplus
+}
+#endif
+
+#endif /* SETUP_H_ */