./workspace/TS100 -> ./source/

source/Core/BSP/BSP_QC.h

@@ -0,0 +1,42 @@
+/*
+ * BSP_QC.h
+ *
+ *  Created on: 29 May 2020
+ *      Author: Ralim
+ */
+
+#ifndef BSP_BSP_QC_H_
+#define BSP_BSP_QC_H_
+#include "stdint.h"
+#ifdef __cplusplus
+extern "C" {
+#endif
+
+// Init GPIO for QC neg
+void QC_Init_GPIO();
+// Set the DP pin to 0.6V
+void QC_DPlusZero_Six();
+// Set the DM pin to 0.6V
+void QC_DNegZero_Six();
+// Set the DP pin to 3.3V
+void QC_DPlusThree_Three();
+// Set the DM pin to 3.3V
+void QC_DNegThree_Three();
+// Turn on weak pulldown on the DM pin
+// This is used as a helper for some power banks
+void QC_DM_PullDown();
+// Turn off the pulldown
+void QC_DM_No_PullDown();
+// Turn on output drivers that were initally disabled to prevent spike through QC disable mode
+void QC_Post_Probe_En();
+// Check if DM was pulled down
+// 1=Pulled down, 0 == pulled high
+uint8_t QC_DM_PulledDown();
+
+// Re-sync if required
+void QC_resync();
+#ifdef __cplusplus
+}
+#endif
+
+#endif /* BSP_BSP_QC_H_ */