Adding adc2 & new temperature calibration proceedures. [WiP] (#361)

* Add rough calls to ADC2 [untested]

* Using dual ADC injected modes

* Start both ADCs

* Move some IRQ's to ram exec

* Stabilize PID a bit more

* Add in ideas for tip type selection

* Add tiptype formula / settings struct

* Add function ids to the settings menu

* Rough tip selection

* Rough out new cal routine for simple tips

* Hardware test is fairly close for first pass

* Add Simple calibration case [UNTESTED]

This adds the calibration option that uses boiling water to the calibration menu.

This is untested, and may need gain adjustments before use.

* Simple Cal Roughly working

* Rough out advanced cal

workspace/TS100/inc/hardware.h

@@ -14,11 +14,21 @@ extern "C" {
 #endif
 
 enum Orientation {
-    ORIENTATION_LEFT_HAND = 0,
-    ORIENTATION_RIGHT_HAND = 1,
-    ORIENTATION_FLAT = 3
+	ORIENTATION_LEFT_HAND = 0, ORIENTATION_RIGHT_HAND = 1, ORIENTATION_FLAT = 3
+};
+/*
+ * Keep in a uint8_t range for the ID's
+ */
+enum TipType {
+	TS_B2 = 0,
+	TS_D24 = 1,
+	TS_BC2 = 2,
+	TS_C1 = 3,
+	Tip_MiniWare=4,
+	HAKKO_BC2=4,
+	Tip_Hakko=5,
+	Tip_Custom=5,
 };
-
 #define KEY_B_Pin GPIO_PIN_6
 #define KEY_B_GPIO_Port GPIOA
 #define TMP36_INPUT_Pin GPIO_PIN_7
@@ -54,6 +64,7 @@ uint16_t ftoTipMeasurement(uint16_t temp);
 uint16_t tipMeasurementToF(uint16_t raw);
 
 void setCalibrationOffset(int16_t offSet);
+void setTipType(enum TipType tipType, uint8_t manualCalGain);
 #ifdef __cplusplus
 }
 #endif